Lubefree (LF) replacement turbine for the Midwest Tradition power lever and push button dental handpieces. Stainless steel, lubefree bearings. End cap is NOT included.
Made in the USA. Turbine has a 6 month warranty.
Replacement Parts:
End cap wrench (#15-97-W)
Spindle and impeller (#25-303)
Turbine o-rings (#15-82-OR)
*For other parts available, please call.
Instructions for Midwest Tradition LF Turbine (PDF):
- Before replacing turbine, carefully examine handpiece head for any dents. If there are any dents, then call American Dental Accessories for repair.
- Then using specialized turbine wrench to unscrew end cap and remove worn turbine out the front of handpiece.
- Inspect head for foreign debris and remove if present. Use a hand scaling instrument to remove any old turbine parts, including any shims, o-rings, washers, or bearing retainers.
- Once all debris and parts have been removed, use a cotton swab and handpiece lubricant to clean handpiece head. Using air from an air/water syringe, blow out handpiece to remove any cotton fibers.
- Turbine includes o-rings, which replace the existing turbine o-rings. One o-ring fits onto the lip on the front bearing of the rubine and rests against a lip inside the head. Second o-ring will fit into the groove in the end cap.
- Holding handpiece face down, insert new turbine fully into the head. Use appropriate tool to screw end cap down until flush against handpiece.
- Before opperating handpiece, install bur securely into turbine. If there is any resistance, then you need to remove the rubine and reinstall again.
- Lastly, install handpiece onto tubing connector and operate foot control to make sure it runs smoothly.
Lubefree (LF) replacement turbine for the Midwest Tradition power lever and push button dental handpieces. Stainless steel, lubefree bearings. End cap is NOT included.
Made in the USA. Turbine has a 6 month warranty.
Replacement Parts:
End cap wrench (#15-97-W)
Spindle and impeller (#25-303)
Turbine o-rings (#15-82-OR)
*For other parts available, please call.
Instructions for Midwest Tradition LF Turbine (PDF):
- Before replacing turbine, carefully examine handpiece head for any dents. If there are any dents, then call American Dental Accessories for repair.
- Then using specialized turbine wrench to unscrew end cap and remove worn turbine out the front of handpiece.
- Inspect head for foreign debris and remove if present. Use a hand scaling instrument to remove any old turbine parts, including any shims, o-rings, washers, or bearing retainers.
- Once all debris and parts have been removed, use a cotton swab and handpiece lubricant to clean handpiece head. Using air from an air/water syringe, blow out handpiece to remove any cotton fibers.
- Turbine includes o-rings, which replace the existing turbine o-rings. One o-ring fits onto the lip on the front bearing of the rubine and rests against a lip inside the head. Second o-ring will fit into the groove in the end cap.
- Holding handpiece face down, insert new turbine fully into the head. Use appropriate tool to screw end cap down until flush against handpiece.
- Before opperating handpiece, install bur securely into turbine. If there is any resistance, then you need to remove the rubine and reinstall again.
- Lastly, install handpiece onto tubing connector and operate foot control to make sure it runs smoothly.